I apologize for not being able to figure this out even with the stickies and search bar but here is my problem/s.
I recently just got Clearwire which is a Wireless at home internet service. I checked my settings with the TCP analyzer and found quite a lot wrong, here is my list.
« SpeedGuide.net TCP Analyzer Results »
Tested on: 03.06.2010 20:44
IP address: 71.21.xxx.xx
Client OS: Windows Vista
TCP options string: 020405500103030201010402
(MTU is not fully optimized for broadband. Consider increasing your MTU to 1500 for better throughput. If you are using a router, it could be limiting your MTU regardless of Registry settings.)
TCP Window: 65700 (NOT multiple of MSS)
RWIN Scaling: 2 bits (2^2=4)
Unscaled RWIN : 16425
(RWIN is not fully optimized (even though it is a comparatively large number). The unscaled RWIN value is lower than it should be. Also, RWIN being close to and above 65535 does not justify the header overhead of enabling TCP 1323 Options. You might want to use one of the recommended RWIN values below.)
Recommended RWINs: 65280, 130560, 261120, 522240, 1044480
BDP limit (200ms): 2628kbps (329KBytes/s)
BDP limit (500ms): 1051kbps (131KBytes/s)
MTU Discovery: ON
IP ToS: 00000000 (0)
I tried using the TCP Optimizer to change the MTU but when i reset windows and loaded up the analyzer again it said the same thing.
I am using Windows Vista, I already ran the Vista Patch thing from this site as well. the advertised download rate is 6Mb, which is what..500kb'ish a sec?
Basically I just want to optimize this baby as best I can as far as latency goes.
I understand wireless is suppost to have high latency but i am rather sure it is too high for its own good, I had wireless before this and it was considered too high and it pinged around 90-110, this one is about 15 times faster as far as speed goes and its pinging 200ish..
Any help would be great. Thanks.