Restoring a disk image after RAID-0 set up...

[Burke]

I have an existing image of a clean Windows XP install I made using Drive Image 2002.

If I were to set up a RAID-0 and partition the disk the exact same way as it was before, would restoring the disk image work normally? I figure since the OS sees the RAID-0 as a single drive and since the partitions (especially the C: partition that would hold the OS) are the same it would work without a hitch, but I'm not sure.

[cyberskye]

Any time you restore to a different place than you backedup you are rolling the dice. I know some people have had problems removing the RAID card and trying to boot from the same disk using the onboard IDE. THey were getting BSODs.

Your mileage may vary.

Skye