Linksys Router and ICUII Program

[Punkeeboy]

Hi. I recently purchased a Linksys cable/DSL router Model BEFSR41. Since hooking this up I cannot use the ICUII Program (Video part). The ICUII web site has a short message on how to fix the problem but call me stupid, I just can't figure it out. If anyone knows anything about how to resolve this problem I would be very appreciative of your advice. Thanks again.

[ 02-28-2001: Message edited by: Punkeeboy ]

[lroberts]

I hope you intended to type BEFSR41 (EtherFast 4-Port Cable/DSL Router). I have six BEFSR41's and one BEFSR81. Perhaps you have the `Deny WAN Request' enabled.

The BEFSRx1's also uses NAT (Network Address Translation). NAT keeps your systems IP Address from getting out on the WEB. Most people do not register their IP Addresses with InterNIC. Duplicate addresses on the Internet will cause a lot of problems.

Perhaps the site requires access to your system and can't get through the router's NAT interface.