100M/Bit and full duplex?

[chrille]

HI I have a little question for you guys.
I have two computers that have Netgear FA310TX (Nic:s with 10/100,pci,full duplex support. I also have a Netgear FS105 10/100 Switch. How do I tell If I have full duplex enabled?
//Chrille

[Storm90]

Can you check in the network properties. Under your Netcard it may give you the information you want. Some cards just automaticly adapt to the there connection. Hope this helps.

[chrille]

Ok thanks =), I read somewhere that you should use autosensing, but as It happens I can't enable that on one of the machines (W2k,SP1). Is there any programs out there that might shed some light over this question.

[glc1]

chrille, the switch should have a full-duplex LED indicator.

[chrille]

Damn I feel like a Idiot =). Why haven't I thought of that. A closer look on the switch Itself proved to be a good thing..arghhh. There It was "Green=FDX", and just below It two green led's. I'm not In the land of the ignorant anymore =). Thank's ALOT http://www.speedguide.net/ubb/smile.gif). You proved right. I've learned a lesson today. That goes, being a jackass and refuse to read any type of documentation Is one thing but one can take a look at the unit itself =)