View Full Version : Router Problems with Road Runner Turbo
kimberwyn
05-24-08, 03:46 PM
We just upgraded to Roadrunner Turbo. When we try to use this service w/ our router (Wireless G Access Point by Linksys; its about a year old, tops) the internet becomes ridiculously slow. Im not sure exactly what speed, but it was loading about the same as dial up AOL would, and when I tried to reset it, it became even slower and eventually stopped working all together.
Turbo is working just fine without the router though (downloading at 13818 kb/s). Does anyone know if there is a special type of router that is needed for high speed internet?
mccoffee
05-27-08, 11:45 AM
Change your wan port of your router to 100 full duplex to do that log on to your routers inteferface ,and wan settings it might be under a different tab though.
Same deal for me.. upgraded yesterday to turbo. only getting half the downstream as w/out router. It was probably similiar before i upgraded, just now tested.
I'm running a befsr41 v2 old as dirt. It has no wan settings that i can see.
Any advice? sorry for the hijack but pretty much same problems here.
---
After further reading I'm seeing max wan throughput is 10mbs on the v2
On another note, Have RR check your lines, i had a kink in one cable that was f'n with the signal strength. It wasnt even noticeable till the upgrade.
mccoffee
06-04-08, 08:27 PM
for the hyjacker you might want to look into routers with faster wan ports I use a dlink dir 625 which can support higher speeds.
vBulletin® v3.8.4, Copyright ©2000-2010, Jelsoft Enterprises Ltd.