Linsys wirless g

[gentlebenus]

OK, Iam having major problems with Linksys wireless G roter. Everything was worknig fine until I disabled DHCP. When trying to enable it again, I cant connect to anything. I calle dtech support and they ran me throug the prcess but no lick.
I upgraded the firmware but still no luck. eveything in the configuration looks good except for the internet settings. it will except the internet settings when I click on connect.

I am using SBC DSL

Any advice would be great.

[qball15j]

If all else fails reset the router to it's factory defaults.
You'll see a little pin-hole on the back of the router, press that in while you unplug and re-plugin the router. This will reset it to factory defaults.

[gentlebenus]

I did that with tech support on the phone a couple of times.

These are the steps that I performed; unpluged all cat5 cables,held in the reset button for 30 seconds,unpluged power for 30 seconds, pluged power back in .

I also did a "reset to factory default" while inside the router in setup.


If I am using SBC DSL what is the router supposed to be set to in ISP settings, is it PPPoE or DHCP. The Tech support people were confusing the hell out of me

Thanks